Rosemount Smart Wireless Gateway Specifications download pdf (Page 13)

Reference Manual

00809-0200-4420, Rev HB

Section 2: Initial Connection

January 2015

5Initial Connection

Section 2 Initial Connection

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5

System requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 6

Initial setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 6

2.1 Overview

This section describes how to connect to the Gateway for the first time and what settings should

be configured before placing it on a live control network. It is important to note that some

Gateways are used in stand-alone applications and do not reside on a network. In these cases, it

is still important to configure the items outlined in this section.

Before the Gateway can be permanently mounted and connected to a live control network, it

needs to be configured with an IP address. This is done by forming a private network between

the gateway and a PC/laptop. The following items are needed to complete this section:

 Gateway

 PC/laptop

 24 VDC (nominal) power supply

Note

If the Gateway was ordered with the DeltaV

™

Ready option, it has been configured to operate on

a DeltaV control network, and the Initial Configuration Section does not need to be completed.

Only setting the password is required.

Failure to follow these installation guidelines could result in death or serious injury.

 Only qualified personnel should perform the installation.

Explosions could result in death or serious injury.

 Verify the operating atmosphere of the transmitter is consistent with the appropriate

hazardous locations certifications.

Electrical shock could cause death or serious injury.

 Use extreme caution when making contact with the leads and terminals.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

conditions:

 This device may not cause harmful interference.

 This device must accept any interference received, including interference that may

cause undesired operation.

 This device must be installed to ensure a minimum antenna separation distance of 20

cm from all persons.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

No comments

Rosemount Smart Wireless Gateway Specifications Page 13